E-4
OPERATING INSTRUCTIONS
FUNCTION ICON DESCRIPTION
This button will not only put the fireplace insert in a standby mode, but also you can
see the flame effect through the screen. This will turn off all functins at once.
Note: Holding the POWER button for 3 seconds will turn on the Child safety lock. It
disables or enables all functions on the control panel and remote control.
The fireplace contains a fan forced heater.
The default setting temperature is 72°F (22°C).
The thermostat setting range is 50°-86°F or 10°-30°C.
The thermostat is adjustable by 2°F or 1°C increments.
To change between °F and °C press and hold the HEATER button for 5 seconds.
Press the ECO button when the heater is on, to run the heater in a reduced wattage
range.
Note: Holding the ECO button for 3 seconds disables any heater functions.
To quickly heat up a cold room/space, press the BOOST button to run the heater at
the full rated wattage.
Pressing the BOOST button repeatedly will cycle through the following boost settings:
5 minutes, 10min, 15min, 20min, 25min, 30min and off.
Pressing the timer button repeatedly will cycle through the following timer settings:
30 minutes, 1 hr, 2 hr, 3 hr, 4 hr, 5 hr, 6 hr, 7 hr, 8 hr and off.
The fireplace will automatically turn off when the timer reaches zero minutes.
This button controls the brightness of the flame effect.
POWER
HEATER
ECO
BOOST
TIMER
BRIGHTNESS
To Next Page
Loading...
