Masterflex Ismatec Reglo 78018-10

Questions and Answers

C
Craig DavisAug 11, 2025
How to troubleshoot motor not rotating and display not lighting on Masterflex Ismatec Reglo 78018-10?
- D
  dwatsonAug 12, 2025
  If the motor of your Masterflex DC Drive doesn't rotate and the display doesn't light, it's likely due to a power issue. First, ensure the power cord is securely plugged into the drive and the mains power outlet, and that the power is switched on. Also, inspect the power cord for any visible damage and replace it if necessary.
D
Dr. Michelle BrownAug 18, 2025
What to do if Masterflex DC Drives pump doesn't rotate during remote operation?
- P
  Patrick WeberAug 18, 2025
  If your Masterflex DC Drives pump doesn't rotate and the display doesn't light up during remote operation, the issue might be a defective remote control or a setting error. Here's what you can do: 1. Switch the pump drive off, then check that the DB-25 connection cable is fully inserted into the drive's port. 2. Switch the pump drive back on. 3. If the motor still doesn't rotate, select REMOTE from the Mode Selection screen and/or the Settings screen and verify that the settings are correct.
S
Sarah LopezAug 27, 2025
Why is the touchscreen unresponsive on my Masterflex Ismatec Reglo 78018-10 DC Drives?
- C
  carriegillespieAug 27, 2025
  If the touchscreen on your Masterflex DC Drives is unresponsive, it might be because you are wearing thick latex gloves. Remove the gloves before using the touchscreen.
R
Robert AdamsSep 3, 2025
How to fix weak calibration strength on Masterflex DC Drives?
- M
  mayleslieSep 3, 2025
  If you observe a weak calibration strength displayed on the calibration strength bar of your Masterflex DC Drives, it could be due to a poor calibration volume or flow rate. To improve calibration accuracy, consider using a larger calibration volume and/or altering the flow rate.