12
CAUTION:
CAUTION:
CAUTION:
CAUTION:
Always be sure that the tool is switched off and
unplugged before attempting to perform
inspection or maintenance.
Never use gasoline, benzene, thinner or alcohol to clean
the plastic housing of any tool as discoloration, deformation
or cracks may result.
All of the bearings in this tool are lubricated with a sufficient
amount of high-grade lubricant for the life of the unit under
normal conditions. Therefore, no further lubrication is
required.
Replacing
Replacing
Replacing
Replacing carbon
carbon
carbon
carbon brushes
brush
es
brushes
brushes
1. Limit mark
CAUTION:
CAUTION:
CAUTION:
CAUTION:
If you need any assistance or more details regarding these
accessories, call the toll-free helpline at: 1-866-915-8626.
Dust hood
Roller guide assembly
Straight guide assembly
Collet 1/4"(installed with router)
Collet 3/8"
Collet wrench
Carbon bru
shes
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the
holders. Both carbon brushes should be replaced at
the same time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.
1. Screwdriver
2. Brush
holder cap
To maintain product SAFETY and RELIABILITY,
always use
original replacement parts.
ACCESSORIES
ACCESSORIES
ACCESSORIES
ACCESSORIES
MAINTEN
MAINTEN
MAINTEN
MAINTENA
A
A
ANCE
NCE
NCE
NCE
These accessories/attachments are
recommended for use with your MasterForce tool
specified in this manual. The use of any other
accessories/attachments might present a risk
of injury to persons. Only use the accessories/
attachments for their stated purpose.
ACCESSORIES INCLUDED IN PACKAGE
1
2
1
Roller guide
assembly
Straight guide
assembly
Collet wrench
Carbon
brushes
Canvas bag
Dust hood
To Next Page
Loading...
