2
Important Safety information
Your MasterTop® Bimini Top Plus and Wind Stopper are intended to increase the fair weather enjoyment of
your off-road capable vehicle. Before installation, please take a moment to review the following safety
information and installation instructions. Important safety information is generally preceded by one of three
signal words indicating the relative risk of injury. The signal words mean:
WARNING
CAUTION
A hazardous situation which, if not avoided, could result in death or serious injury.
You CAN be KILLED or SERIOUSLY HURT if you don’t follow instructions.
A hazardous situation which, if not avoided, could result in minor or moderate
injury.
You CAN be moderately HURT and also may suffer property damage if you don’t
follow instructions.
NOTICE
Careful attention is required to this instruction or operation but does generally not
relate to personal injury. Damage to your MasterTop product or other property may
result if you don’t follow instructions.
Before you begin Installation:
We are excited that you have chosen the MasterTop Bimini Top Plus and/or Wind Stopper! These high-
quality tops are designed to enhance your fair-weather driving pleasure while providing needed shade while
driving in the hot sun. Please note that it is important that you become familiar with the installation process of
this top by reading the following instruction sheet and warnings thoroughly. Though we use only the finest
materials in creating this top, any product that is exposed to the elements requires some general
maintenance to keep it looking like new. Please see page 7 for these important maintenance tips. Please
also note that it is normal for the vinyl fabric to contract and wrinkle when stored in the shipping carton. In a
few days the fabric will relax and wrinkles will disappear.
Threading Straps through Buckles:
Throughout the installation, you will need to thread webbing straps through buckles se-
veral times. Please review the picture for correct strap routing through the buckles. As a
rule of thumb, run the strap below and through the sewn side of the buckle rst and then
back down through the end of the buckle. Tighten the strap by simply pulling the exposed
webbing after threading the strap through the buckle.
NOTICE
For a smooth t and ease of installation, this top should be installed at tempera-
tures above 72 degrees. Below this temperature, the fabric may contract an inch
or more making it difcult to install. We highly recommend taking the top out of
the package and letting it sit inside a warm place or direct sunlight for 1-2 hours
before you install the top. When warm, this top will install quickly.
When unpacking, check to make sure all parts are included.
If any part is missing or broken, please call MasterTop customer service at 720-575-5440.
Pre-Installation of Bimini Top:
Windshield Seal Information:
Your MasterTop Bimini Plus has a reinforced rubber seal that is sewn
into the front edge of the top to help block water and debris from
entering the cab.
This seal must be tucked into the gap between the windshield and
the roll bar as shown above to help prevent water from entering the
cab. This seal does not make this top water tight!
See the notice below:
NOTICE
Though this top is made of waterproof materials, it is not waterproof. Water can
enter the cab in-between the doors and the roll bar as well as possible leakage
around the front rubber seal near the windshield.
This top must be removed when putting your soft or hard top back on your vehicle.
To Next Page
Loading...