MATALA Biosteps10 - Page 4

Waste Drain-Out Fitting Installation:
▪Insert drain socket through lower hole in section 1.
▪Place one O-ring on inside AND one O-ring outside of the lter over the
threads.
▪Hand tighten nut. Do not over tighten.
Inlet Fitting Installation:
(Photo shows installation with optional UVC.)
▪Align and insert UVC upper male thread into female thread of clear hose
socket. Twist clear hose socket fully onto the male threads of the UVC.
▪The O-ring is installed first over the clear hose socket and then the
clear hose socket is installed through the hole in the section 1.
▪Hand tighten nut 3/4 tight. Do not over tighten.
Option 3)
Biosteps10 with Waterfall Spillway option.
▪Check alignment of spillway with upper outlet hole in section 6 of body.
▪The top of spillway should t ush against the body.
▪Align spillway with upper hole in lter body and insert outlet tting through
hole.
▪Install one O-ring on inside of lter body over the male threads.
▪Hand tighten nut.
▪Install one O-ring over threads of outlet tting.
▪Insert outlet tting through inside of spillway.
▪Finished
3