Preparing the camera before first use
1. Charging: the camera is containing a high-capacity rechargeable battery. In order to extend battery life, please charge it completely before using.
Charging options: (1) connect to the computer USB interface
(2) use the power adapter (5V 1-2A)
(3) use the car charger
BATTERY LED COLOR CHART:
Battery LED colors and LED flashing for battery status
Battery nearly runs out (need to charge as soon as possible)
Battery runs out (the camera will save the recording automatically
before shutting down)
The red LED will remain on during charging
The red LED will turn off after fully charged
(Note: The camera can be used while charging but is better to turn it off while charging in order to extend battery life.)
2. Insert the Micro SD card into the camera
Micro SD card capacity and speed is affecting the camera usage.
Supports up to 128GB Micro SD cards. Use genuine Micro SD cards, at least Class10 High-Speed Card.
Press Power button for 3-5 seconds. (This will turn off the camera if you take this action when camera is on). The camera does a quick self-check, the
LED lights will light up in turn to make sure everything is operational, then run back to the default state 2K LED and entering into the stand-by mode.
Press the Shutter button for 10 seconds in stand-by mode, to format the Micro SD card into FAT32 format.
Note: If there is something wrong during operating the camera, please use a pin or other toll smaller than 1 mm diameter to reset the camera and the
system will be reset automatically.
Turn the camera on (2K default) and press the Mode button if you want to change the Video Mode. 7 modes are cyclic switched by the blue LED light
as: 2K --》1080p --》720p --》VGA --》Photo --》Motion Detection --》4K --》2.7K. When the desired resolution is selected you can press the Shutter
button to start recording. Motion detection function will start automatically.
When using it outdoor please use the accessories which came with the package to fix the camera safety on the helmet or on other sport equipment.
Connect the phone APP to set your preferences then you can use just the camera for video recording or taking photos, for FPV by using its video out
feature or installed inside waterproof case when diving or snorkeling and so on.
Auto start & stop: camera automatically records at default 2K@30fps when power is detected while connecting to the car charger.
Parking monitoring function: connect the phone APP and enter into advanced settings Menu, and enable parking monitoring function.
When camera is turned off but is detecting a shock or vibration it will automatically turn on and record for 1 minute, then it will automatic shutdown
if no more shocks are detected (Power Safe Mode).
To Next Page
Loading...