23| Revision Date: 8/30/2017 | Revised by: EM
f. Press
Install All Updates
.
g. Press
Yes
.
h. Wait until the software update is complete.
i. When the update is complete and the console automatically returns to the standard display, turn off the power.
j. Wait 30 seconds before turning on the power.
k. Press
Enter 3 0 0 1 Enter
to open Service Mode.
l. Touch the
General
tab and verify the software versions are correct.
m. Press
Enter 7 3 2 6 6 8 Enter
to reboot the system.
n. Test the console:
i. If the issue has been resolved, return to the Update Manager and set the Update Source to
HTTP
.
ii. If the issue has not been resolved, review Table 1, 2, or 3 to continue the troubleshooting steps.
Instructions for upgrading TV database software (case 3 only)
1. Press
Enter 3 0 0 4 Enter
to open Update Manager.
To Next Page
Loading...
