one connector to the input signals on the other connector.
This allows the computer and the Door to perform full-duplex
Ethernet communication.
DIRECT DOOR
COSEC Monitor PC
Crossover/Straight Cable
Once the IP address of the DIRECT DOOR has been
changed from its display as explained, proceed with the
further configuration of the DOOR Controller as explained in
the COSEC System Manual.
However, the user needs to keep a note of the IP settings as
set on the DIRECT DOOR as the same would have to be
entered in the Network parameters section on the Doors
option page of the COSEC application.
The PANEL DOORs on the other hand are assigned their IP
addresses by the PANEL based on the Controller Network
Parameters as defined in the Network Parameters page of
the COSEC Jeeves application as explained in the COSEC
PANEL Quick Start as well as the COSEC System manual.
To Next Page
Loading...