55
7.2.8 Times of use
Lawn mowers are only permitted to be used on
workdays between the hours of 7.00 a.m. and 7.00
p.m. Please comply with statutory regulations,
which may vary from location to location.
7.3 Preparing the mower for long-term
storage
Caution: Do not empty the petrol tank in
enclosed areas, near re or when smoking. Petrol
fumes can cause explosions and re.
1. Empty the petrol tank with a petrol suction
pump.
2. Start the engine and let it run until any
remaining petrol has been used up.
3. Change the oil at the end of every season. To
do so, remove the used engine oil from a warm
engine and rell with fresh oil.
4. Remove the spark plug from the cylinder head.
Fill the cylinder with approx. 20 ml of oil from an
oil can. Slowly pull back the starter handle, which
will bathe the cylinder wall with oil. Screw the
spark plug back in.
5. Clean the cooling ns of the cylinder and the
housing.
6. Be sure to clean the entire machine to protect
the paint.
7. Store the machine in a well-ventilated place.
7.4 Preparing the mower for transportation
1. Empty the petrol tank (see item 7.3.1).
2. Always let the engine run until it has used up
the remainder of petrol in the tank.
3. Empty the engine oil from the warm engine.
4. Remove the spark plug boot from the spark
plug.
5. Clean the cooling ns of the cylinder and the
housing.
6. Remove the start tension cable from the hook
(Fig. 8). Slacken the wing nuts and fold down the
upper push bar.
7. Wedge a few layers of corrugated cardboard
between the upper and lower push bars and the
engine in order to prevent any chang.
7.5 Ordering replacement parts
Please quote the following data when ordering
replacement parts:
• Type of machine
• Article number of the machine
• Identication number of the machine
• Replacement part number of the part required
8. Disposal and recycling
The unit is supplied in packaging to prevent its
being damaged in transit. This packaging is raw
material and can therefore be reused or can be
returned to the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of
as special waste. Ask your dealer or your local
council.
To Next Page
Loading...
