11
-Opentheejectorasdescribedinthefollowing
andcleantheinteriorwithadampcloth.
-Useasti
brushtoremovedi cult deposits.
Cleaning the Material Ejector
-Weargloves.
- Unscrew the knob.
- Pull the feed hopper upwards and then open it.
-Cleandirtandwoodresidueo
the ejector and
cutting surfaces. Don’t use force.
-Closethefeedhopper;pullitupwardsandpush
it forwards into the front position; then, push it
down.
-F
irmly tighten the knob.
-Iftheejectorcasingisnotseatedperfectly,a
safety switch prevents the motor from starting.
If this occurs, unlock the feed hopper again as
describedaboveandmakesurethatitseats
properly.
Changing the Blades
-Pullthepowerpl
ug.
-Weargloves.
- Check blades for damage.
-Makesurethatonlyoriginalsparepartsare
used.
-Ifthe3cuttingbladesaredull,theycanbetur-
ned.
-Loosenthe2All
enscrews;turnthebladesand
then tighten them again.
Technical Data
Mains voltage: 230V~/50Hz
Power consumption: 2400 Watts
Idling speed: 2880 min-1
Max. branch thickness: 40 mm
Capacity: approx. 150 kg/hr
Acoustic pressure L
PA : 98dB(A)
Sound power level L
WA: 107dB(A)
Weight: 12.5kg
Repairs
Only use accessories and spare parts recommend-
ed by the manufacturer. If the equipment should
fail some day in spite of our quality controls and
your maintenance, only have it repaired by an
authorised electrician.
Environmental Protection
Do not simply dispose of the equipment, accesso-
ries and packaging in the rubbish bin, but bring it
for environmentally sound recycling.
The small
ort involved in this is for the of
our environment.
To Next Page
Loading...
Need help?
General
