8
ENGLISH
BEFORE YOU BEGIN
PROPER USAGE
This equipment offers a variety of foot positions. Moving your foot
to the forward most position of the foot pad increases your step
height, which will create a feel similar to a step machine. Placing
your foot toward the back of the foot pad decreases your step height
and creates more of a gliding feel, similar to a smooth walk or run.
Always make sure your entire foot is secured on the foot pad.
This equipment also allows you to pedal both forward and backwards
to offer a variation to your workout and to focus on other major
leg muscle groups such as your hamstrings and calves.
To determine proper workout position, stand on the pedal with
your foot on the center of the pedal. Keep your knees slightly
bent at all times. You should be able to pedal without locking
your knees or shifting your weight from side to side.
BRAKE SYSTEM
This equipment utilizes magnetic resistance to set specific
levels of resistance. The resistance level setting in addition to
the RPM is used to determine the power (watts) output.
MAINTENANCE
1. Any and all part removal or replacement must be performed by a qualified service technician.
2. DO NOT use any equipment that is damaged and or has worn or broken parts. Use
only replacement parts supplied by your country’s local MATRIX dealer.
3. MAINTAIN LABELS AND NAMEPLATES: Do not remove labels for any reason. They contain
important information. If unreadable or missing, contact your MATRIX dealer for a replacement.
4. MAINTAIN ALL EQUIPMENT: Preventative maintenance is the key to
smooth operating equipment as well as keeping your liability to a
minimum. Equipment needs to be inspected at regular intervals.
5. Ensure that any person(s) making adjustments or performing maintenance or
repair of any kind is qualified to do so. MATRIX dealers will provide service
and maintenance training at our corporate facility upon request.
WARNING
To remove power from the unit, the power cord must be disconnected from the wall outlet.
MAINTENANCE SCHEDULE
ACTION FREQUENCY
Unplug the unit. Clean entire machine using water and a mild soap or
other Matrix approved solution (cleaning agents should be alcohol and
ammonia free).
DAILY
Inspect the power cord. If the power cord is damaged, contact Customer
Tech Support.
DAILY
Make sure the power cord is not underneath the unit or in any other area
where it can become pinched or cut during storage or use.
DAILY
Check all connecting joint areas for tightness of bolt assemblies. QUARTERLY
Ensure that there is little, or no free play at all joint assemblies once bolts
have been tightened. Installation of washer kits may be required if free
play does not come out from tightening bolts.
QUARTERLY
Unplug the unit and remove plastic covers. Lubricate ball joint where the
Link Arm and Dual Action Handlebar join together. A grease gun, with
a needle fitting adapter is required for this (Matrix recommends using
Superlube brand grease with PTFE {Teflon} additive).
QUARTERLY
Unplug the unit and remove plastic covers. Lubricate Acme screw on
incline motor (Matrix recommends using Superlube brand grease with
PTFE {Teflon} additive).
QUARTERLY
To Next Page
Loading...
