CHAPTER 2: Troubleshooting
2.3.３ TROUBLESHOOTING - INCLINE MOTOR ISSUES
SOLUTION:
a. While using the machine press the "INCLINE" keys, the console should beep and display incline
change, if no, replace the key pad.
b. Enter Engineering Mode, and scroll to ENG 1 (Hardware Test). Press the “ENTER” key
first and then the “START” key.
c. Press the “INCLINE ▲/▼” key.
If can hear clicks from two relays and LED light (see table 2.2.2 and 2.2.4) at the MCB, the MCB is
ok. Then check the connection of the elevation motor at the MCB. First try to unplug and re-plug
connection . If this does not resolve the issue, replace the elevation motor.
If there is no clicks from these two relays or LED light, MCB is defective and replace the MCB.
16
To Next Page
Loading...
Need help?
General
