1. Export settings from an already-configured console.
2. Access the Product Dashboard by touching and holding on the Matrix logo, top center of
display.
3. Press the “Machine Settings” button.
4. Type “3 0 0 1 enter” on the keypad that appears to access Machine Settings menu.
5. Touch on the “Network Setup” tab.
6. Touch on the “Import Settings” button.
After successfully importing settings, the console will automatically connect to the configured network if
in range.
To forget a Wi-Fi SSID:
1. Access the Product Dashboard by touching and holding on the Matrix logo, top center of display.
2. Press the “Machine Settings” button.
3. Type “3 0 0 1 enter” on the keypad that appears to access Machine Settings menu.
4. Touch on the “Network Setup” tab.
5. Find the SSID to be forgotten in the presented list; touch & hold on it for ~6 seconds – it should
disappear when released. If not, press & hold again for longer.
6. After releasing touch, choose to “Forget this Network” on the dialog that appears.
Reference for Wi-Fi connection signal strength icons:
Wired Internet Setup
Wired internet (ethernet) is available on all cardio frames.
The console will connect automatically to the internet when an ethernet cable is connected to the
frame's ethernet port and the network is properly configured."
Reset Wi-Fi Connection
Some Wi-Fi connection issues can be resolved by resetting the connection.
To reset the Wi-Fi connection:
1. Access the Product Dashboard by touching and holding on the Matrix logo, top center of display.
2. Press the “Machine Settings” button.
3. Type “3 0 0 1 enter” on the keypad that appears to access Machine Settings menu.
4. Touch on the “Network Setup” tab.
5. Touch on “Advanced WIFI Settings” button.
6. Touch on “Reset”.
The console will disconnect from and immediately reconnect to the same Wi-Fi network.
To Next Page
Loading...
