CHAPTER 4: Part Replacement Guide
4.8 U50 ECB CONTROLLER REPLACEMENT
1) Disconnect wires of induction brake and any wire ties.
2) Loosen 4 fixing bolts one full turn.
3) Loosen tension bolts nuts to remove drive belt.
4) Remove 4 fixing bolts and remove ECB unit.
5) Reverse steps to replace ECB unit.
NOTE: Drive belt tension 135-155Hz.
4.9 SEAT REPLACEMENT
1) Remove the 2 seat screws (circled below).
2) Remove seat and seat clamp.
3) Reverse steps to install seat.
To Next Page
Loading...
