Printer must be installed in an area large enough to
allow for normal operation of the printer. [minimum
1000 mm from each side of the printer]
After unpacking printer can be pushed to its
final destination , once set make sure wheels
are disabled in order to get best balance
possible. Additional balancing can be done
by rotating red wheel on each foot.
[ 6 of them in total ]
Red wheel for lowering fix foot
Wheel used for moving printer
Fixed foot [can be moved up/down for
balance ]
SITE PREPARATION GUIDE
SITE PREPARATION GUIDE
M A T R I X U V 1211/2511, CUBEJET 1211/2511, MONSTERJET 1211/ 2511
Printer is shipped in wooden crate. Due to the delicate nature of the equipment, it is essential that you have the proper equipment
available for handling and moving the shipping crates. Before opening them, you should check the condition of the box. If it is
damaged, you should immediately inform us. All equipment must be uncrated by a qualified service engineer.
Printer with transport box Only Printer
Width 1600mm(62,99in) Width 1860mm(73,22in)
Length 2600 mm(102,36in)
Length 2200mm(86,61in)
/ 3500mm(137,79in)
Height 1410-2040 mm
(55,51-80,31in)
Height 1120-1750 mm
(44,09-68,89in)
Weight: 900-1100 kg Weight 400 kg /710 kg
azonprinter.com MATRIX GETTING STARTED
To Next Page
Loading...
Need help?
General