- 13 -
TROUBLESHOOTING (AE150E)
1. Problem: No LED lit.
Possible Cause: AC end is not making a good connection.
Solution: Check for poor connection at AC side.
2. Problem: Green LED keeps blinking.
Possible Cause: Clamps are not making a good connection.
Solution: Check for poor connection at battery and frame.
3. Problem: Red LED illuminated right away when connecting
onto a battery.
Possible Cause:
a. Incorrect battery voltage.
b. Battery is at full charge capacity
Solution:
a. Verify that charger selector switch is in correct 12V
position to match the battery’s voltage. The charger will give
you a warning if you are connecting to the incorrect
application.
b. The battery is currently at full charge and will continue in
maintenance/float mode until voltage drop occues. At the time
of voltage drop, charger will resume in maintenance charging
mode.
To Next Page
Loading...
