3. Press one of digit keys (0-9)
Make a call from two-touch memory
In off-hook or at hands-free state, press STORE key + digit key (0-9) key, the relevant number
will be dialed out.
LOW BATTERY DETECTION
When the voltage of batteries is lower than 3.9V, LCD displays “” icon to remind the user to
replace the batteries.
LCD BACKLIGHT FUNCTION
The backlight is turned on when receiving an incoming call, dialing, pressing any key or in
MUSIC HOLD mode. It will fade off if the telephone is left idle for 10 seconds.
NOTE: If batteries are not loaded, there will be no LCD backlight function.
FLASH FUNCTION
The flash time is 100ms, flash function is available working in special PABX.
PAUSE FUNCTION
If dial a number from PABX extension, press PABX number (normally “0” or “9”) + ALARM/P +
desired number. When redial, need not dial PABX number and ALARM/P key, just press
REDIAL key
LOCK
Turn the key to yellow point, all numbers are locked except emergency numbers 110, 119, 120,
122, 911, 115, 113 and 118.
Turn the key to green point, all numbers starting with “0” are locked.
Turn the key to red point, all numbers are allowed to be dialed out.
BABYCALL FUNCTION
At on-hook state, press and hold REDIAL key for 3 seconds to come into baby call function
setting. LCD displays BABYCALL OFF, press REDIAL key to set it ON, press SET key. LCD
displays NO CODE (or the preset baby call number, press DEL key to cancel), input baby call
number using numerical key and press SET key to confirm.
After set baby call function to ON state, pressing any key except REDIAL key or picking up
handset will dial the baby call number automatically 32 times.
When baby call function is ON state, you can still answer the incoming call or parallel call by
handset.
NOTE: If you don’t use the function, enter baby call function setting as per above operation and
select BABYCALL OFF, press SET key to confirm.
To Next Page
Loading...
Need help?
General