mode is set as Tone.
SETTING PABX CODE
1. In on-hook state, press and hold DEL key 3 seconds to set PABX code, LCD displays
SET PCODE - and the “-” flashes.
2. Press UP/+ or DOWN/– key to set PABX code from 0 to 9 or -.
3. If choose “-”, it means no PABX code has been set.
4. Press SET key to confirm and quit.
HOLD ON MUSIC
Hold music selection
There are 3 kinds of hold music for selection
1. At off-hook state or hands free, press HOLD key
2. Press OUT/× key to select the desired hold music. It plays the music at same time.
3. Press UP/+ or DOWN/– key to select the 4 steps volume of hold music.
4. Press HOLD key to quit.
When talking over handset, press HOLD key to enter the hold mode and the hold
music is sent out. In hold mode:
1. Press HOLD key to release hold mode and continue to talk over handset.
2. Or hang up handset, it enters hands-free hold mode.
When talking at hands-free mode, press HOLD key to enter the hold mode and the
hold music is sent out. In hold mode:
1. Pick up handset to talk over handset.
2. Or press key to quit hold mode and talk at hands-free mode.
ONE TOUCH MEMORY OPERATION
Store the number in one-touch memory
1. Pre-dial the desired number or checking incoming and outgoing number that you want to
store.
2. Press STORE key
3. Press M1 key
Make a call from one-touch memory
In off-hook or on-hook situations, press M1 key to dial the stored number out.
TWO TOUCH MEMORY OPERATION
Store the number in two-touch memory
1. Pre-dial the desired number or checking incoming and outgoing number that you want to
store.
2. Press STORE key
To Next Page
Loading...
Need help?
General