To Next Page
L
Lance PageAug 8, 2025
How to turn on the ID LED on a MAXDATA PLATINUM 2200 IR Server?
- DDawn DoyleAug 8, 2025
To turn on the ID LED on your MAXDATA Server, you can either press the ID LED button or use the Server Management software.
How to turn on the ID LED on a MAXDATA PLATINUM 2200 IR Server?
To turn on the ID LED on your MAXDATA Server, you can either press the ID LED button or use the Server Management software.
How to troubleshoot a MAXDATA PLATINUM 2200 IR when the Power LED is off?
If the Power LED on your MAXDATA Server is off, check if the power supply is properly connected.
Instructions for connecting the server to power and peripherals.
Describes diagnostic LEDs on the server board for troubleshooting.
Details RAID capabilities and controller options for storage.
Lists processor and memory requirements, and memory channel configuration.
Specifies compatible DDR3 DIMM types, speeds, and configurations.
Covers safety precautions, tools, and system reference points for installation.
Step-by-step guide to removing and replacing the server's top cover.
Instructions for installing SAS or SATA hot-swap hard disk drives.
Steps for replacing a hot-swap power supply unit.
Step-by-step guide for installing DDR3 DIMMs into the server.
Detailed instructions for installing or replacing the server processor.
Procedures for resetting CMOS and BIOS to default settings.
Safety warnings related to handling server components during installation.
General
