Handlebars
1.Remove the long screw (please save the screw for later
use) the two caps, the ring and from the head tube
2.Make sure to unlock the handlebar stem by lifting the
latch and put the handlebar onto the front fork where you
removed the parts and protection from step 1
3.Align the front fork, front wheel, and handlebar
4.Put the long screw into the hole from the head tube
underneath the latch and tighten it by hand then an Allen
key clockwise
5.Lock up the latch and tighten the two small screws on the
head tube
Video:
https://www.youtube.com/watch?v=2-fxSShk
KwY
To Next Page
Loading...
