Maxi Climber XL User Manual

Remove knobs securing pistons from adjusting tubes and place them on cylinder bracket.

Remove upper handlebars by detaching the knob.

Take off the steel rope from the adjusting tubes.

Remove curved stabilizer by detaching screws, nuts, and washers.

Remove screws, nuts, washers, and cushions from the bottom of the machine.

Take off the connecting sheet of the rear stabilizer to detach the U bracket.

Slide adjusting tubes towards the machine bottom until they exit completely.

Remove screws from adjusting tubes and take off pulleys for replacement.

Remove screws, pulleys, cross head bolt, and flat head bolt to replace plastic roller.