Head Pillow
(on select models)
Only For Use in
Rear-Facing Mode
To remove, from the back of
the head pillow gently pull the
fabric tabs out of the shoulder
harness slots.
To attach, slide the fabric tabs
into the shoulder harness slots.
4
Harness Covers
(on select models)
For Use in Rear-Facing Mode or
Forward-Facing Mode
If the harness covers will not allow
proper positioning of the chest clip or
interfere with getting a tight enough
harness fit for a smaller baby, remove
them and DO NOT use.
Store them until your child is large
enough to use the harness covers
while maintaining a properly fitting
harness.
To remove, pull the fastening strips
apart and pull the harness covers off
of the harness straps.
To Next Page
Loading...
