Maximum Controls MAX ARM - Page 27

25
MAX Arm/Ultra Arm V1
REV. 06/14/22
max ultra arm
15. Re-lock Manual release.
16. Learn newly adjusted limits on control box. Push the OPEN button, gate will open
and learn open limit. Push the CLOSE button, gate will close and learn close limit.
NOTE: Gate may not ramp down when approaching limits while “LEARNING”
gate positions but will ramp down after limits have been learned.
CAUTION: If BEEP/ALARM is NOT heard, readjust front bracket position.
“BEEP/ALARM”
10. Make sure gate remains in OPEN position. Loosen adjustment screw on OPEN limit switch and slide switch until BEEP/ALARM
is heard. Tighten adjustment screw when finished.
12. Make sure gate remains in CLOSE position. Loosen adjustment screw on CLOSE limit switch and slide switch until
BEEP/ALARM
is
heard. Tighten adjustment screw when finished.
Limit Cover
Limit Cap
14. Replace limit cap with 2 screws
and slide limit cover on operator.
pull open ultra arm continued
13. When satisfied with Open and Close positions of gate, permanentely secure front bracket.
MOTION CONTROL
OPEN STOP CLOSE
Learn Adjusted Limits
NOTE: If limits need to be re-adjusted, then they MUST be cleared first from control box memory, see #1 above.
Adjusting Limits
(See note below)
Adjusting Limits
(See note below)
Re-lock Manual Release
Adjustment Screw
OPEN Limit Switch
Gate is OPEN
Gate is CLOSED
Adjustment Screw
CLOSE Limit Switch
“BEEP/ALARM”
11. Manually move gate to CLOSE position.
Close
NOTE: If 2 consecutive beeps are heard
when moving gate to CLOSED position, then
adjust gate to FIRST beep position.
PULL OPEN
OPEN LIMIT
ADJUSTMENT
CLOSE LIMIT
ADJUSTMENT
PUSH OPEN
Max = 60.3” (+/-.39“) (1531 mm (+/- 10 mm)
7.35”
186mm
5.07”
128mm
5”
127mm
2
MAX Ultra Arm V1
Limit
Switch
Limit
Switch
PULL OPEN
OPEN LIMIT
ADJUSTMENT
CLOSE LIMIT
ADJUSTMENT
PUSH OPEN
Max = 60.3” (+/-.39“) (1531 mm (+/- 10 mm)
7.35”
186mm
5.07”
128mm
5”
127mm
2
MAX Ultra Arm V1
Limit
Switch
Limit
Switch
PULL OPEN
OPEN LIMIT
ADJUSTMENT
CLOSE
LIMIT
ADJUSTMENT
PUSH OPEN
Max = 60.3” (+/-.39“) (1531 mm (+/- 10 mm)
7.35”
186mm
5.07”
128mm
5”
127mm
2
MAX Ultra Arm V1
Limit
Switch
Limit
Switch
PULL OPEN
OPEN LIMIT
ADJUSTMENT
CLOSE LIMIT
ADJUSTMENT
PUSH OPEN
Max = 60.3” (+/-.39“) (1531 mm (+/- 10 mm)
7.35”
186mm
5.07”
128mm
5”
127mm
2
MAX Ultra Arm V1
Limit
Switch
Limit
Switch
PULL OPEN
OPEN LIMIT
ADJUSTMENT
CLOSE LIMIT
ADJUSTMENT
PUSH OPEN
Max = 60.3” (+/-.39“) (1531 mm (+/- 10 mm)
7.35”
186mm
5.07”
128mm
5”
127mm
2
MAX Ultra Arm V1
Limit
Switch
Limit
Switch
Max = 60.3” (+/-.39“) (1531 mm (+/- 10 mm)
7.35”
186mm
5.07”
128mm
5”
127mm
2
MAX Ultra Arm V1
Limit
Switch
Limit
Switch
PULL OPEN
CLOSE LIMIT
ADJUSTMENT
OPEN LIMIT
ADJUSTMENT
PUSH OPEN
PULL OPEN
PULL OPEN