IMPORTANT: Correct install position
CAUTION:
Ensure mains power is OFF before commencing installation.
The supplied mains cable must not contact the top surface of the heater during operation.
Heater must not be located immediately below a socket outlet. Electrical connections must be made outside
of the footprint
of the unit to avoid heat build-up. If the heater is to be mounted on an incline (e.g.
sloping roof), ensure the electrical connection is located below the lowest end of the heater.
Joists, beams and rafters shall not be cut or notched to install the appliance.
This heater is not intended for ceiling-recessed installation. Do not install pointing directly downwards.
The identification mark and model reference should be visible after installation.
The STAR must not be attached facing or close to any combustible material (eg, wood or PVC cladding, fascia
or soffit)
or other materials that could blow onto the heater.
The fixed wiring insulation coming into contact with parts with a temperature rise of greater than 50°C must
be protected, for example, by sleeving having an appropriate temperature rating.
Exercise caution when siting the heater stand that the heater cannot accidentally be touched, knocked-over
or that the wire
causes a tripping hazard.
Never place the stand and heater next to a swimming pool, pond or other water source.
INITIAL USE:
The unit may emit odour or vapour on initial use or if heater has not been used for an extended period.
This is norma
To Next Page
Loading...