Maxon M-KIT112 - Adding The Pedestal

Page 13 of 13 M-KIT112/113/114 Assembly Instrucons 181-03005
These instrucons must be followed exactly. Failure to follow these instrucons could damage the product or result in injury to persons
using or assembling the product. Maxon Furniture Inc. shall not be liable for any costs, loss, damage, expenses or injuries resulng from
failure to properly assemble the product in accordance with these instrucons.
Maxon Furniture Inc. Customer Service: 1-800-876-4274
Adding The Pedestal
1. Unpack the SYP20B-R Systems Pedestal and
remove the drawers.
2. Insert four Standard Spacers into the holes on
the Pedestal top (Figure 24).
3. Posion the Pedestal under the Rectangular
Worksurface.
4. Insert a 1/4” Socket Wrench through the
Glide Access Holes to adjust the four Leveling
Glides unl the Standard Spacers touch the
boom of the UWR2436TM Rectangular
Worksurface (Figure 24).
5. Install four Pedestal Screws inside the
Pedestal, through the Spacers, and into the
boom of the Rectangular Worksurface
(Figure 24).
6. Replace the Pedestal drawers (Figure 25).
Figure 25
Figure 24
Standard Pedestal Spacer
Standard
Pedestal Screws
Glide Access Holes