Maxon M-KIT112 - Installing Panel Trim

Page 7 of 13 M-KIT112/113/114 Assembly Instrucons 181-03005
These instrucons must be followed exactly. Failure to follow these instrucons could damage the product or result in injury to persons
using or assembling the product. Maxon Furniture Inc. shall not be liable for any costs, loss, damage, expenses or injuries resulng from
failure to properly assemble the product in accordance with these instrucons.
Maxon Furniture Inc. Customer Service: 1-800-876-4274
Installing Panel Trim
1. Pull down all of the Raceway Covers on the
outside of the Panels by gently pulling on the
top of the Raceway Covers (Figure 8).
2. Install one Corner End Cap onto each of the
three corners (Figure 8).
3. Install one EC1E Raceway End Cover onto the
end of each PL6624 Panel inside the Raceway
Covers (Figure 9). Two EC1E End Covers will
be installed.
4. Close the Raceway Covers.
Flanges at top of
Corner End Cap
Raceway Covers
Corner
End
Caps
EC1E
Tab at top
Figure 9
Figure 8