Maxon M-KIT112 - Page 6

Page 6 of 13 M-KIT112/113/114 Assembly Instrucons 181-03005
These instrucons must be followed exactly. Failure to follow these instrucons could damage the product or result in injury to persons
using or assembling the product. Maxon Furniture Inc. shall not be liable for any costs, loss, damage, expenses or injuries resulng from
failure to properly assemble the product in accordance with these instrucons.
Maxon Furniture Inc. Customer Service: 1-800-876-4274
10. Add the two remaining PL6636 Panels
by inserng a Straight Alignment Bracket
between the adjoining panels and connecng
with the I-Beam Panel Connectors (Figure 5).
11. Trim the excess I-Beam Panel Connector length
with wire cuers or snips as in Step 6.
12. To secure the PL6636 Panels, center the Lock
Bar over two Panels (Figure 5) and aach
with two (2) #8 x 1/2” Flat Head Self Drilling
Screws (Figure 6).
13. Repeat Step 12 to secure the last two PL6636
Panels.
14. Repeat Steps 3 - 6 to aach the two PLCP66
Corner Posts to the PL6636 Panels (Figure 7).
15. Repeat Steps 7 - 9 to aach two PL6624
Panels. This completes the installaon of the
Raceway Panels.
PL6624
Corner Posts
Top View
#8 x 1/2" Phillips
Flat Head
Lock Bar centered
over panels.
Figure 7
Figure 6
Figure 5
Straight Alignment
Bracket
#8 x 1/2" Phillips
Flat Head Screws
Lock Bar
I-Beam Panel Connectors
Glides