Maxon M-KIT112 - Installing the Panels

Page 5 of 13 M-KIT112/113/114 Assembly Instrucons 181-03005
These instrucons must be followed exactly. Failure to follow these instrucons could damage the product or result in injury to persons
using or assembling the product. Maxon Furniture Inc. shall not be liable for any costs, loss, damage, expenses or injuries resulng from
failure to properly assemble the product in accordance with these instrucons.
Maxon Furniture Inc. Customer Service: 1-800-876-4274
Installing the Panels
1. Slide/pry the Top Cap from each Panel end
being careful not to damage the parts (Figure
1).
CAUTION! The following steps may
require assistance to complete.
2. Posion the PL6636 Panels in their
approximate installed placement and level by
turning the glides on the boom of the Panel
Frame with a 1/2 inch wrench.
3. On one PL6636 Panel, insert one Straight
Alignment Bracket into the notch located on
the panel’s edge at the boom of the Panel
Frame (Figure 2).
4. Place one PLCP66 Corner Post on top of the
Straight Alignment Bracket.
5. Connect the PLCP66 Corner Post to the
PL6636 Panel by sliding plasc I-Beam Panel
Connectors down the grooves in between the
Corner Post and the Panel’s edge (Figure 3).
TIP! You will need 4 I-Beam Panel
Connectors to ll each groove.
6. Using wire cuers or snips, trim the excess
I-Beam Panel Connector length so that the
grooves are completely lled and ush with
the Panel Frame top.
7. Place one PL6636 Panel against the Corner
Post at a 90 ° angle from the rst Panel.
8. Insert one Angle Alignment Bracket (Figure 2
& Figure 4) into the slots of the two Panels
being connected.
Tip! Use two slots near the boom to
help eliminate interference with future
accessory installaons.
9. While holding the Angle Alignment Bracket in
place, connect the second Panel by inserng
the I-Beam Panel Connectors as directed in
Steps 5 - 6.
Figure 1
Panel end
Top Cap
Figure 2
PL6636
Panel
PL6636
Panel
I-Beam Panel Connectors
PLCP66
Corner Post
Top View
Figure 3
Figure 4
Angle Alignment
Bracket
Straight Alignment
Bracket
Corner
Post
Glide
90
Exterior
Assembly View
Angle
Alignment
Bracket
I-Beam Panel Connectors