Maxon M-KIT112 - Adding the Corner Shelf

Page 9 of 13 M-KIT112/113/114 Assembly Instrucons 181-03005
These instrucons must be followed exactly. Failure to follow these instrucons could damage the product or result in injury to persons
using or assembling the product. Maxon Furniture Inc. shall not be liable for any costs, loss, damage, expenses or injuries resulng from
failure to properly assemble the product in accordance with these instrucons.
Maxon Furniture Inc. Customer Service: 1-800-876-4274
Adding the Corner Shelf
The Corner Shelf will be installed onto the two
PL6636 Panels in the back corner of the cubicle.
Each P anel has a vercal row of slots on the end
for aaching components (Figure 12).
1. Install the Le-hand Shelf End Panel with the
top tooth at 5 slots down on the le PL6636
Panel. The Shelf End Panel will drop down
into the slots on the PL6636 Panel (Figure
13).
2. Repeat for the Right-hand Shelf End Panel.
ATTENTION! Ensure that the Shelf End
Panel Teeth are fully engaged with the
Panel slots.
3. Insert a Back Strip into the Le PL6636 Panel
by lng the boom of the Back Strip up
towards you. Allow the top tooth to go into
the exposed panel slots at the boom of
the Shelf End Panel (Figure 14). At the back
corner, insert the top tooth so the Back Strip
is level with the Shelf End Panel.
4. Rotate the Back Strip down to lock in place.
5. Repeat Steps 3 - 4 to install the Back Strip on
the right PL6636 Panel (Figure 15).
Left-hand
End Panel
Back Strip
Bottom View
Figure 14
Figure 13
Top tooth in
5th slot from
the top
End
Panel
Figure 15
Back Strips
Left-hand
End Panel
Right-hand
End Panel
Left PL6636
Panel
Right PL6636
Panel
Figure 12