Maxon M-KIT112 - Page 10

Page 10 of 13 M-KIT112/113/114 Assembly Instrucons 181-03005
These instrucons must be followed exactly. Failure to follow these instrucons could damage the product or result in injury to persons
using or assembling the product. Maxon Furniture Inc. shall not be liable for any costs, loss, damage, expenses or injuries resulng from
failure to properly assemble the product in accordance with these instrucons.
Maxon Furniture Inc. Customer Service: 1-800-876-4274
6. Install the Shelf by placing the sides of the
Shelf into the Shelf Holding Brackets [on the
Shelf End Panels] and pushing it down into
place.
7. Make sure that the Shelf is fully seated and
ush with the Holding Brackets.
TIP! Pushing down by hand is usually
sucient, but light taps with a rubber
mallet may be necessary.
8. Use three #8 x 1/2 “ Washer Head Screws to
aach each Back Strip to the Shelf.
CAUTION! Hold down the Shelf while
installing the screws. Otherwise, the
upward force may li the Shelf and End
Panels o the Panels.
Figure 16
Figure 17
Shelf
Bottom View
Shelf Holding
Bracket
Left-hand
End Panel
Shelf
#8 x 1/2" Washer
Head screw
(3 in ea. Back Strip)
Back Strip
Insert Shelf flange into
Shelf Holding Bracket