Maxon M-KIT118 - Final Worksurface Attachment

Page 11 of 11 M-KIT118/119/120 Assembly Instrucons 181-03007
These instrucons must be followed exactly. Failure to follow these instrucons could damage the product or result in injury to persons
using or assembling the product. Maxon Furniture Inc. shall not be liable for any costs, loss, damage, expenses or injuries resulng from
failure to properly assemble the product in accordance with these instrucons.
Maxon Furniture Inc. Customer Service: 1-800-876-4274
With the Spanner Clips near the front and 8.
back edges of the Rectangular Worksurface
(about 22” apart), aach the Spanner Clips
to the Rectangular Worksurface using one
#10 x ¾” Panhead Screw in each Spanner Clip
(Figure 14).
Aach the Canlever to the Rectangular 9.
Worksurface with three #10 x ¾” Panhead
Screws.
Repeat steps 6 - 9 for the other three 10.
Rectangular Worksurfaces.
#10 x 3/4" Panhead Screw
(2 in each Spanner Rail,
3 in each Cantilever for
a total of 20)
Figure 14