Maxon OD808 User Manual

28
* Be sure the battery is firmly connected to battery snap with the correct polarities.
BATTERY REPLACEMENT
This product operates on one 9V battery (6LR61 or 6F22). Follow the procedures
below to replace batteries:
BATTERY REPLACEMENT
ATTENTION:
① ② ③
■ Turn down the volume of effect and amplifier to the minimum before
connecting Maxon effects to guitar, amplifier or other effects in order not
to damage other connected equipment by unintended noise.
■ When not in use, disconnect plug from input jack to preserve battery.
■ Take out the battery if the product is not used for a long period of time.
■ No or dark LED light indicates the battery is low or not installed. In this
case replace the battery to avoid poor effect or distorted signal.
■ Be sure to use the correct Maxon AC adaptor. Use of any other
adaptor may cause trouble.
■ Do not try to remove screws.

Maxon OD808 Specifications

General

Type	Overdrive
Controls	Drive, Tone, Level
Power Supply	9V DC
Weight	580 g
Technology	Analog
Input Impedance	500 kOhms
Output Impedance	10 kOhms
Inputs	1 x 1/4"
Outputs	1 x 1/4"
Power Source	9V Battery or AC Adapter
Current Draw	6mA at 9V