20
PT9Pro
+
Phaser
FEATURES AND CONTROLS
●PT9Pro+ by use of high-performance light dependent resistor device and ten-
stage phasing provides studio quality smooth phase sound with low noise.
●PT9Pro+ uses a stabilized DC-DC voltage converter to bump 9 volts up to
plus and minus 9 volts. PT9Pro+ provides wide dynamic range and sufficient
head room against distortion.
①IN (input jack)
Input jack to connect to the output of
guitar, other effects or related equipment.
The product automatically turns on when
a plug is inserted into this jack. When not
in use, disconnect plug from input jack to
preserve battery life.
②OUT (output jack)
Output jack to connect to the input of
amplifier or other effects.
③SPEED (speed control knob)
Controls modulation rate. Turn this knob
clockwise for faster modulation.
④FEEDBACK (feedback control knob)
Controls effect level of modulation. Turn
this knob clockwise for PT9Pro+’s
characteristic effects with unique
modulation. The fully clockwise position
may cause a self-oscillation, which you
can cut off by turning this control counter-
To Next Page
