- All equipment must be properly grounded according to MAXON
installation instructions for safe operation.
- All equipment should be serviced only by a qualified technician.
Refer to the appropriate section of the product service manual for additional
pertinent safety information.
MAXON MOBILE INSTALLATION SAFEGUARDS
Some electronic fuel injection, anti-skid breaking systems, cruise controls,
and vehicle alarms may be prone to interference from radio frequency
energy or may malfunction due to lack of protection from RF energy. If the
vehicle contains such equipment, consult the dealer or factory and enlist
their help in determining whether the electronics equipment in the vehicle
will operate properly when the radio is transmitting.
• Do not install the unit where it would likely cause injury in case of vehicle
accident.
• Mount the unit so that the user can easily see and reach all controls and
the microphone.
• After selecting a location for the radio, hold the mounting bracket in
place. Using the bracket as a template, mark the spots where the
bracket securing screws will be located with a pencil.
• Before drilling holes in the vehicle, verify that there is nothing that could
be damaged or get in the way by drilling and putting screws in this
location.
• Try to get access to the back side of the surface where the bracket is to
be mounted, and verify that it is safe to use this location.
• It is better to use existing passages in the dashboard, trunk, and floor for
the routing of cables, thus avoiding excessive drilling.
NOTE: THIS RADIO IS NOT INTENDED FOR OPERATION IN A
POSITIVE GROUND VEHICLE!!!
To Previous Page
Loading...
