Fig.13
5.5.3 High Temperature
When the heater is running, the surface of the exhaust pipe will reach a high temperature. Ensure that this pipe is
installed far away from plastic components or other objects with the poor thermal resistance on the vehicle body. The
exhaust pipe shall be properly mounted, with its vent pointed downwards and perpendicular to the road, at an angle
of 90°±10° (as shown in Fig. 13). To maintain the correct angle, the exhaust pipe fixing clamp shall be mounted within
150 mm of the pipe end.
10°
10°
All types of combustion produce high temperatures
and toxic exhaust fumes; this is the reason the exhaust
system must be installed strictly according to these
instructions.
Do not perform any work on the exhaust system while the
heater is working.
Before working on the exhaust system, first switch the heater off,
wait until all parts have cooled down completely, and wear
safety gloves if necessary.
Do not inhale the exhaust fumes.
The manufacture disclaims any liability for consequences
resulting from failure to install the device in accordance with the
requirements of this manual.
Risk of injuries and burns!
WARNING
5.6 Inspection Before Use
The heater should be debugged before use. during
commissioning, carefully check all connections for
leakage and safety, if heavy smoke emission is
observed or irregular combustion noise or fuel smell is
felt, the heater must be turned off. please remove the
fuse so that the heater will not work, the heater must
be maintained by qualified professionals before it can
be put into use. the details are as follows:
1. Check the air inlet and outlet for contamination and
foreign matter.
2.
Clean the outside of the heater.
3. Check the electrical contacts for corrosion or loose
connections.
4. Check the intake pipe and exhaust pipe for blockage
and damage.
5. Check the fuel line for leakage.
PARKING AIR HEATER
25
PARKING AIR HEATER
26
To Next Page
Loading...
