Why does my MaxPower CT60 thruster lack power?
To address a lack of power in your MaxPower Boat thruster, verify the propellers are properly fitted. Also, check the battery size, ensure the batteries are sufficiently charged, and confirm all connections are correctly tightened. It's also important to inspect the power cable sections, referring to page 6 for recommended cable sizes.
What to do if the relay clicks but the motor doesn't run on my MaxPower CT60?
If the relay is clicking but the motor isn't running on your MaxPower Boat, you should check the motor's power fuse, the main battery isolator, and the internal relay contacts. Additionally, verify the battery conditions and connections to ensure they are in good working order.
How to fix a MaxPower CT60 control panel that doesn't light up?
If the control panel of your MaxPower Boat does not light up, check the 6-wire connector behind the joystick and the thruster's electronic control box 6-wire connector. Also, inspect the circuit breaker/switch in the boat's main DC distribution panel and the control box's power fuse (8 A).
What to do if the motor runs but the thruster doesn't work on my MaxPower CT60?
If the motor is running but the thruster isn't working on your MaxPower Boat, first check that the propellers are fitted correctly. Then, inspect the motor/drive leg assembly. Also, ensure the tunnel isn't obstructed and the propellers aren't blocked.
To Next Page
General