Contents
1.0 INTRODUCTION 4
1.1 PRE-INSTALLATION NOTES 4
1.2 PRODUCT VARIATIONS 5
1.3 SPECIFICATIONS 6
2.0 INSTALLATION 8
2.1 SELECTION OF POSITION FOR THE WINDLASS 8
2.2 PREPARATION OF MOUNTING AREA 9
2.3 PREPARATION OF THE WINDLASS 10
2.4 INSTALLING THE WINDLASS 11
2.5 SELECTION OF MOTOR STARTER 13
2.6 POWER CONNECTIONS TO AC MOTOR 14
2.7 POWER CONNECTIONS TO DC MOTOR 15
2.8 POWER CONNECTIONS TO HYDRAULIC MOTOR 15
2.9 INSTALLATION OF CONTROLS 16
2.10 NOTE TO BOAT BUILDER 17
3.0 USING THE WINDLASS 18
3.1 PERSONAL SAFETY WARNINGS 18
3.2 LOWERING THE ANCHOR UNDER POWER 19
3.3 RETRIEVING THE ANCHOR UNDER POWER 19
3.4 LOWERING THE ANCHOR UNDER MANUAL CONTROL 19
3.5 OPERATING THE WARPING DRUM INDEPENDENTLY 20
4.0 MAINTENANCE 21
4.1 WINDLASS MAINTENANCE 21
4.2 BAND BRAKE MAINTENANCE 22
4.3 RECOMMENDED LUBRICANTS 22
4.4 SPARE PARTS 23
4.5 TOOLS FOR MAINTENANCE 23
5.0 TROUBLESHOOTING 24
APPENDIX A - Dimensional drawings 26
APPENDIX B - Spare parts 29
APPENDIX C - Installation schematics 38
APPENDIX D - Network of Agents and Distributors 42
APPENDIX E - Warranty Form 47
To Next Page
