INSTALLATION INSTRUCTIONS,
INFORMATION AND OPERATING GUIDE
for MAXXFAN
®
Mini MODELS 4301M and 4401M
for MAXXFAN
®
and MAXXFAN
®
Plus MODELS
4000K, 4001K, 4002K, 4050K, 4201KW, 4251KW,
4301K, 4401K, 4500K, 4501K, 4541K, 4700K, 4751KS,
4761KS, 4800K, 4801K, 4900K, 4951KS
WARNING! To reduce risk of re, injury to persons or damage to property, use only
in the manner intended by AIRXCEL, INC. Should you have questions, please contact
AIRXCEL/MAXXAIR VENTILATION SOLUTIONS Customer Service at 316.832.4357.
P/N: 11F90000K
01-2018
READ AND SAVE THESE INSTRUCTIONS
NOTE: Refer to Installation Instructions, Information and Operation Guides regarding the
model you have purchased.
The MAXXFAN installs into a standard RV roof opening of 14 by 14 inches.
To determine if your roof opening is correctly sized, simply remove the interior ceiling garnish
trim ring of your existing roof vent and measure the ceiling opening or verify the opening is
large enough by sliding the MAXXFAN interior Garnish trim ring into the opening.
The MAXXFAN Mini is designed for a minimum roof thickness of 1 inch to a maximum
of 6 1/2 inches.
The MAXXFAN/MAXXFAN Plus is designed for a minimum roof thickness of 2 inches
to a maximum of 6 1/2 inches. If your roof thickness is less than 2 inches, build additional
thickness at the ceiling opening using wood or other suitable material.
The MAXXFAN requires a minimum 12 Volt DC, 5 amp service. Conrm that the circuit
you intend to use will accommodate the additional load. Use the proper gauge stranded
wire for electrical connections.
MAXXFAN
®
To Next Page
Need help?
General
