MaxxMar Cool Motion - Solo-A1 Rechargeable Wand Control; Basic Operation

New Generation Solo-A1 Maxx Motor (with Bluetooth)
Rechargeable Wand Control System with Internal Battery Motor
12V DC with Battery Charger
Battery Charging
- Plug the micro USB cable into the charging port
located at the bottom of the wand
- Please recharge motor battery when motor
alarm sounds off (DI, DI-DI) or motor begins to falter
- Charging time: 7 hours - please take the charger away
when charging is complete
New Generation Solo-A1
MAXX MOTORS
Operation & Programming Instructions
Command
Key Combination
Description
Illustration
Go Up
Hold UP for
1 second
Move all the way to the upper
limit
1
Press Up
Press UP or Down
Move all the way to the lower
limit
1
Stop ongoing motion
Press DOWN
Double press UP
Double press
DOWN
Move the motor up in small
increments
Move the motor down in small
increments
Move the motor to favourite po-
sition number one
1.
Basic Operation
Go Down
Stop
Step Up
Step Down
Go to Favourite
Position #1
Go to Favourite
Position #2
Move the motor to favourite po-
sition number two
2
Note: 1. The motor will stop on button release if the limit is not yet set.
2. The motor will take no action if the favourite position is not yet set.
Hold DOWN for
1 second
MaxxMotor NEW GEN Solo-A1-Instructions_Layout 1 20-02-06 2:58 PM Page 1