MaxxMar MAXX - Page 4

Command
Item
Key Combination
Description
Illustration
Upper
Limit
Setting
Favourite
Position
Setting
Switch
Roller/
Horizontal
Mode
Horizontal
Mode
Trouble-
shooting
6
Press UP button
Motor goes up
9
Press button once at
bottom of wand
Press STOP button
when close
to the upper limit
position
Press UP or DOWN
button to adjust the
final position
7
8
Motor stops
1
2
3
Press UP or
DOWN button
Press and hold
SETTING button and
then press and hold
UP button
Press STOP
button to adjust the
final position
Motor sounds DI once: upper
limit setting has been set
Press STOP button when
blinds reach your favourite
position
Release both buttons when
motor sounds DI-DI-DI: the
setting has been completed
Motor goes to the
favourite position and stops
Press SETTINGS button on switch 3 times, the working
mode has been changed from Roller to Horizontal or from
Horizontal to Roller.
Note: The original factory setting is in roller blinds work mode.
Adjust light: press UP or DOWN button less than 2 seconds, motor rotate a certain angle so the blinds
moving step by step.
Normal moving: press and hold the UP or DOWN button for 2 seconds, after which the motor will rotate
continuously towards upper or bottom limit end - otherwise press STOP if limit ends not set properly.
If nothing works, please check:
- whether the battery wand and motor are connected properly;
- whether the battery is charged - if not, recharge motor through wand
If the motor continues to run in one direction, please check:
- the limit setting which may have to be reset again.
Solo A1: Basic Operation and Troubleshooting Continued
4
Maxx - Motorization Instns - Original MaxxMotor - ENG.qxp_Layout 1 2023-04-04 11:42 AM Page 4