MaxxMar MAXX - Page 8

Command
Item
Key Combination
Description
Illustration
Setting
Upper
Limit
Setting
Favourite
Position
Program
Transmitter
using a
Programmed
Transmitter
Delete all
Original
Transmitters
Delete itself
from Motor
Charging
Bluetooth
Operation
FAQ
6
7
8
9
1
2
2
1
3
1
1
2
2
Press UP button on
transmitter
Press STOP button
when motor gets
close to end-point of
upper limit
Press either UP or
DOWN button
Motor runs step by step to adjust
upper limit accurately
Motor jogs up and down.
Limit Setting has been set
Move blind to desired favourite
position
Favourite position has now been
set
Motor will jog again: Transmitter B
has been programmed
Motor stops
Motor runs up
Press UP or DOWN
button
Press and hold LIMIT
button and UP
button at same time
until motor jogs
STOP button now
functions as favourite
Press CONFIRM
button on
Transmitter B
Keep pressing LIMIT
button on Transmitter
A, then press
DOWN button
The motor works with a Li-ion battery, please charge it when the motor alarm goes off or when the motor
begins to falter. Please charge the motor using professional charger CH-8, 4V/1A. Charging time: up to
4 hours or when indicator light turns green. Please disconnect from charger when done
.
Press CONFIRM
button 3 times to jog
Keep pressing LIMIT
button on the first
programmed Trans-
mitter A, then press
CONFIRM button
Press the CONFIRM
button on transmitter
This can only be performed after setting motor limit.
Skip this step and proceed to the next one if the
subsidiary transmitter is not needed.
Motor will run to the favourite
position and stops
Motor will jog, then release both
buttons
This Transmitter has been
deleted from the motor
Release both buttons once motor
jogs: now all transmitters have
been deleted except for
Transmitter A
Cool Motion Rechargeable Bluetooth Battery Motor: Basic Operation & Troubleshooting Continued
8
Download APP from Apple Store or Google Play and use key words 3L SMART BLIND. New users need to
register a new account and follow step 2 below. Subsequent users can share the same account:
App settings via “Sync with existing account” - see menu under SETTINGS.
Press SETTING button on motor 3 times - when motor beeps, the motor is reset and in discoverable mode.
Pease follow all of the APP’s instructions to continue program or operations.
If nothing works, please check:
l
whether power switch on motor is switched to ON.
l
whether Bluetooth has been reset to discoverable mode.
l
whether Cellphone Bluetooth is on and enabling access.
l
If the motor keeps running in the same direction continually, the setup limit needs to be re-set.
Maxx - Motorization Instns - Original MaxxMotor - ENG.qxp_Layout 1 2023-04-04 11:42 AM Page 8