11
ENG
Illustration may vary due to the model
Residual current circuit breaker (depending on model)
To protect the treadmill from damage caused by overvoltage of the mains there is a fault current circuit breaker
next to the main switch on the front of the motor cover. This switch jumps out at an overvoltage and breaks the
circuit, the treadmill is completely switched o. If this happens, turn o the treadmill with the main power switch
and disconnect the power cord from the socket. Push the raised residual-current-operated circuit breaker back
in again. Plug the power cord into the power outlet and turn the treadmill back on using the main power switch.
Backup (depending on model)
To protect the treadmill from damage caused by overvoltage of the mains there is a fuse next to the main switch
on the front of the engine cover. This breaks the circuit in the event of an overvoltage, the treadmill is completely
switched o. If this happens, turn o the treadmill with the main power switch and unplug the power cord from
the wall outlet. Check the fuse and replace if necessary. Then connect the power cord to the Socket and switch
the treadmill back on using the main switch.
To protect the treadmill from being used by unauthorized third parties, always remove the safety key and discon-
nect always the power cord when not in use. Store these separately from the treadmill in a safe place inaccessi-
ble to children
Mains cable
Connect the plus of the mains cable to the corresponding coupling on the treadmill. Then
connect the power cord to a power outlet.
The device may only be connected to an earthed socket installed by professional
installers. Do not use multiple sockets to connect the treadmill. If an extension cable
is required, then it must comply with DIN standards, VDE regulations and guidelines,
technical rules issued by other European Union member states or other states which are
party to the Agreement on the European Economic Area.
Main Switch
The main switch is located next to the power connector on the front of the treadmill. This
switch turns the treadmill on or o.
Switch position “I” = treadmill switched on
Switch position “0” = treadmill switched o
Mains Cable
Disabling Function
Main Switch
Residual-current device /
Fuse
Coupling for
Mains Cable
To Next Page
Loading...
