4
It is important to ensure the cover is fitted centrally onto the front of the caravan.
To centralise the cover; make sure the top and bottom triangular reflectors are central on the
caravan above the drawbar:
The bottom of the cover should sit just above the central drawbar.
It maybe necessary to reduce the length of the awning beading strips to achieve this.
If this is the case; pull the lower end of the awning beading out of the channel and pull down
below the bottom end stop of the channel until the cover sits correctly on the drawbar. Cut off
the excess beading; and re-insert the end of the beading into the awning channel and pull
down to the end stop.
Note – measure this carefully before cutting.
Once central and with the cover sitting just above the drawbar; adjust the top straps to create
tension at the top of the cover.
To Next Page
Loading...