Need help?Do you have a question about the Mayku FormBox and is the answer not in the manual?
General| Category | Desktop Vacuum Former |
|---|---|
| Maximum Draw Depth | 130mm |
| Materials | PETG, HIPS, ABS, Polycarbonate |
| Material Thickness | 0.25mm - 1.5mm |
| Weight | 13kg |
| Vacuum Source | Standard vacuum cleaner |
| Forming Area | 200 x 200 mm (7.9 x 7.9 inches) |
Lists necessary items for setting up the FormBox and connecting peripherals.
Lists items required for the first making project, including the hologram viewer.
Explains how undercuts hinder template removal and are to be avoided in designs.
Describes using draft angles on edges for easier template removal from vacuum forms.
Explains the importance of air holes for proper air flow to the vacuum plate.
Suggests experimenting with different template materials for unique finishes and textures.
Advises placing objects as close to the center of the vacuum plate as possible.
Recommends leaving at least 3cm spacing between multiple objects on the plate.
Recommends templates be wider than tall to prevent thinning at the top of the form.
Warns against sharp angles to prevent 'webbing' and suggests lowering trays softly.
Explains how to mute FormBox operational sounds by holding the timer start button.
Describes how to manually turn off the vacuum during the forming process.
To Next Page
