Installation and Operating Instructions
for ROBA-stop
®
-S Size11 (B.8.3.1.GB)
25/10/2005 K/TK/BG/KR Chr. Mayr GmbH + Co. KG Tel.: 08341 / 804-241
Eichenstraße 1 Fax: 08341 / 804-422
87665 Mauerstetten http://www.mayr.de
Page 1 of 9 Germany eMail: info@mayr.de
Please read and observe this Operating Instruction carefully!
A possible malfunction or failure of the clutch and damage may be caused by not observing it.
Table of contents:
Page 1: - Table of contents
- Manufacturer’s declaration
Page 2: - Safety regulations
Page 3: - Safety regulations
Page 4: - Brake views
- Parts list
- Safety and information signs
Page 5: - Design
- Function
- Supply condition
- Assembly conditions
- Brake attachment
- Tacho-attachment (option)
Page 6: - Air gap inspection
- Air gap adjustment
- Exchange of the rotor
Page 7: - Electrical connection
- Release monitoring
Page 8: - Adjustment of the braking torque
- Emergency release
Page 9: - Anti condensation heating (option)
- Condensation water
- Disposal
- Breakdowns
Manufacturer declaration
The product is to be seen as an option or component for installation into machines or equipment according to the machinery directive
98/37 EC. The machinery (product) must not be put into service until the machinery into which it is to be incorporated has been declared
in conformity with the provisions of the applicable EC-directives.
The product corresponds to the low voltage directives 73/23/EEC.
The observance of the relevant EMC-directive 89/336/EEC is to be guaranteed.
To Next Page
Need help?
General
