Leveling legs align the dishwasher vertically and horizontally. A combination of these
two adjustments are necessary to properly position the dishwasher and insure proper
fit of door and latch. Dishwasher must be LEVEL, solid, and square. Improper leveling
may result in dishwasher leaking.
LEVEL DISHWASHER
LEVEL DISHWASHER
POSITIONING THE DISHWASHER (continued)
POSITIONING THE DISHWASHER (continued)
8
SECURING THE DISHWASHER
SECURING THE DISHWASHER
Make pilot holes in the underside of counter and drive wood screws, provided in the
accessory package, through holes in the dishwasher mounting bracket. If part of
the bracket extends beyond the cabinet front, they may be trimmed with wire
cutters, provided sufficient material is left to support dishwasher mounting.
It may be necessary to provide an additional
anchoring source for mounting screws. Wood
strips across the top of dishwasher opening can be
used for solid surface or granite type counters to secure the dishwasher.
Note: Dishwasher must be secured properly to
countertop to avoid tipping when the door is open and
to prevent the tub from twisting.
Leveling Leg
3/16 Hex Head
Door Spring
Adjustment Screw
Tip: Check to be sure there is no interference with water line
and wiring. Verify that power is turned off at source.
Tip: When installing dishwasher near a corner, allow enough room for the door to open
without interferring with any cabinets, drawers, or hardware.
Tip: Disregard the squareness of cabinets, cabinet trim may be used to correct situation later.
9
DRAIN HOSE ATTACHMENT
DRAIN HOSE ATTACHMENT
If draining into the disposer, check to make sure disposal plug has been removed.
If not, remove as shown.
With dishwasher in permanent position, clamp drain hose to a properly sized
drain line.
Tip: Refer to countertop manufacturer for complete
details on securing dishwasher to countertop.
Do not use
knee to position
dishwasher.
Damage to panel
may occur
To Next Page
Loading...
Need help?
General
