Maytag GT341 - User Manual

Questions and Answers

C
cardenasmarilynAug 21, 2025
Why won't my Maytag GT341 Cooktop burner ignite?
- C
  cobrienAug 22, 2025
  If your Maytag cooktop burner won't ignite, it could be due to several reasons. The top pilots might not be lit, or the ignitors may not be operating correctly; in this case, light the top pilots or correct ignitor operation. Another possible cause is clogged orifice hoods; clean the orifice hoods and verify the size in use is correct. Also, the burner venturi, burner cap, or burner ignition ports might be clogged; clean these components.
C
Christy NavarroAug 30, 2025
How to fix Maytag Cooktop burners that won't ignite but do spark?
- J
  Joshua RodgersAug 30, 2025
  If your Maytag cooktop burners aren't igniting but you see a spark, the burner venturi, burner cap, or burner ignition ports could be clogged; clean the burner venturi or ignition ports. Another possibility is that the air shutters are out of adjustment; adjust them according to the installation instructions. Lastly, if you're using LP gas, the burner flame might not be correctly adjusted; adjust it according to the LP conversion information in the installation instructions.
B
barryvincentNov 10, 2025
What to do if my Maytag GT341 Cooktop burners will not ignite and there is no spark at the burner ignitors?
- R
  Rachel PatelNov 10, 2025
  If your Maytag cooktop burners won't ignite and there's no spark, first, ensure the range is receiving 120 VAC by checking the wall outlet. Next, check your circuit breaker or fuse and reset or replace if necessary. If those steps don't solve the issue, the microswitch contacts may not be closing, so check the activator movement and replace the microswitch if needed. Also, faulty wiring can cause this issue, so check the wiring against the appropriate wiring diagram and ensure all terminals and connections are tight. It could also be an inoperative spark module, so check the module according to the information in the following section, or the ignitor ceramic may be dirty or the spark gap out of adjustment, so clean the ceramic and check the grounding strap spark gap according to the inform...