To Next PageTo Next PageWhat to do if my Maytag MAT12PDA Washer is leaking water?
To address water leaks in your Maytag Washer, inspect the following components: the water valve, fill hoses, hose clamps, injector housing, poly pump, boot seal, and tub cover. Ensure each is properly connected and in good condition.
Why is my Maytag MAT12PDA Washer leaking oil?
If you notice oil around the inside of the cabinet, it could be excess oil from the tub bearing. Wipe it off and monitor if more develops. Oil under the base is likely excess from the brake package; wipe it and observe. Excess oil on the helical shaft and in the rubber dust cap indicates the lip seal in the transmission needs replacement.
General| Brand | Maytag |
|---|---|
| Model | MAT12PDA |
| Type | Top Load Washer |
| Color | White |
| Energy Star Certified | No |
| Water Level Settings | 4 |
| Width | 27 inches |
Explains the function and purpose of ground wires in electrical circuits.
Outlines essential steps and warnings for proper grounding of the appliance.
Details the correct wiring and grounding for 120V wall outlets.
Details how to locate and record model and serial numbers for identification.
Information on locating authorized service and distributors for Maytag products.
Guidance on purchasing replacement parts and accessories for the washer.
Explains the coding system used to identify washer models and their features.
Overview of the washer's operational cycles and component functions.
Addresses common mechanical issues like noise, vibration, and leaks with possible causes.
Explains how to diagnose and troubleshoot electrical circuit malfunctions.
Provides test procedures and expected results for key washer components.
Details methods for electrically testing the washer's drive motor.
Step-by-step guide for removing and accessing the control panel components.
Instructions for removing the manual timer assembly from the control panel.
Procedures for disassembling the coin slide model timer.
Steps for removing the electronic control board from the washer.
Guide for disassembling and removing the touch pad interface.
Instructions on how to remove the cycle selector switch.
Steps to safely remove the transformer from the unit.
Procedures for disassembling the motor run relay.
Guide for removing the reversing motor relay assembly.
Steps to remove the indicator light assembly.
Instructions for removing the lid switch for older models.
Procedures for disassembling the lid switch on newer models.
Guide for removing the pressure switch from the top cover.
Steps to remove the unbalance lever and plunger assembly.
Instructions for removing the air dome and its hose.
Guide for safely removing the water valve assembly.
Procedures for disassembling the meter case.
Steps to remove the coin slide mechanism.
Instructions for removing the coin drop acceptor.
Guide for disassembling the coin sensor.
Steps to remove the service door switch.
Procedures for removing the coin vault switch.
Instructions on how to remove the washer lid.
Guide for removing the front panel of the washer.
Steps to remove the tub cover.
Instructions for removing the balance ring.
Guide for removing the top cover assembly.
Procedures for removing the agitator from the tub.
Steps to remove the access plug.
Guide for removing the inner tub.
Instructions for removing the mounting stem.
Procedures for removing the outer tub.
Steps to remove the tub bearing.
Guide for disassembling the transmission assembly.
Instructions for removing and replacing the transmission lip seal.
Procedures for removing the damper assembly.
Steps to remove the brake package and radial bearing.
Guide for removing and replacing drive and pump belts.
Procedures for removing the drive pulley and rotor bearing.
Steps to remove the water pump assembly.
Guide for removing the drive motor and its base.
