INSTALLATIONREQUIREMENTS
Gather the recommended tools and parts before starting
installation. Read and follow the instructions provided with any
tools listed here.
All Installations
Tools needed:
Pers Flat-blade
• screwdriver
%6" and 1/4" _ _tedlCSA --
nut drivers or _._ Approved twist-on _
hex sockets _ wire connectors*
10 adjustab e wrench %" n n
" " h _ ope -e d
that opens to _JJ_'_ wmn^h _JCJ"
1 _ L,
1V8' (2 9 cm) _,
*Must be the proper size to connect your household wiring
to 16-gauge wiring in dishwasher.
Other useful items you may need:
_ _ Bath _---_i
towel -_" !
Parts supplied:
Drain hose Drain #1oxw, 2_
clamps (2) hose Phillips.head counter
(! large and screws (2) mounting
r ck ts
Make sure all these parts are included in the literature package.
t®TORX and T20 are registered trademarks of Saturn Fasteners, Inc.
Parts needed:
3AComprx 3Ahose fitting
For part or kit, see !ocal
retailer or call Whirlpool
Parts: 1_800-442-9991. Part
Number W10273460
Other parts you may also need:
barrier tape for Solid surface
countertops
(Part Number 8212560)
NOTE: Some parts available for purchase in plumbing supply
stores. Check local codes. Check existing electrical supply. See
"Electrical Requirements" section. It is recommended that
electrical connections be made by a licensed electrical installer.
In addition, for first-time installations
Toolsneeded:
Parts needed:
copper tubing (%, See ',Electrical Requirements" secti0nl
O.D.suggested) or I .- _. :; . I; .. .. .
flexible braided i t-oru_rectwlre: r-orr'ower_upp!y
watersupp y ne I use UL h!sted/ ICord:use
CSA Approved Listed/CSA
I strain relief I Approved power
{,(_1,._._)/_.))),) I tOfit%'! (2,2 cm) supply Cord
hole marked for use with
dishwasher
To Next Page
Loading...
Need help?
General
