Maytag MDB4949SDM User Manual (English)

Questions and Answers:

H
Hannah GloverAug 20, 2025
How to fix Maytag MDB4949SDM Dishwasher that does not run?
- M
  Marcus PierceAug 20, 2025
  If the Start/Resume light is blinking, close the door and press START/RESUME. Ensure the door is fully closed and latched, and that no large dishes interfere with the wash system. Check for items protruding from the racks or tall items hitting the upper rack or spray arm; adjust loading as needed. If lights other than Start/Resume blink, call for service. Also, ensure the Control/Lock feature is off (press and hold SANITIZE for 3 seconds if needed), and that you've selected a cycle. Verify that the dishwasher has power and that no circuit breaker or fuse has tripped.
W
walkerbrittneyAug 22, 2025
Why is my Maytag Dishwasher leaking water?
- D
  dariusgarciaAug 22, 2025
  Ensure the dishwasher is properly installed and level. Excessive suds can cause water leakage, so measure detergent accurately and use only detergents designed for dishwashers. Use less detergent if you have soft water. If sudsing persists, try a different brand of detergent. Secure the rinse aid dispenser lid tightly and avoid overfilling to prevent rinse aid from leaking.
K
Kim BergerAug 25, 2025
What to do if Maytag MDB4949SDM will not fill?
- P
  pennyjohnsAug 25, 2025
  Ensure the water supply to the dishwasher is turned on. Check that the float is free from obstructions. Check for suds in the dishwasher, as foam or suds may prevent proper operation or filling.
P
Patricia ThomasAug 26, 2025
Why is my Maytag MDB4949SDM Dishwasher so noisy?
- L
  Larry PhamAug 26, 2025
  Normal surging sounds occur during draining, and hissing from the water valve is also normal. A snapping sound may be heard when the detergent dispenser opens or when the door is opened. Ensure proper installation and filter installation. Readjust dishware if items extend beyond the racks and interfere with the wash arms.
M
Michelle WeeksAug 27, 2025
What to do if Maytag MDB4949SDM Dishwasher did not sanitize?
- R
  Robert AndersonAug 28, 2025
  If the Sanitized light is blinking, the load wasn't sanitized because the cycle was interrupted or the water heater temperature is too low. Set your water heater to 120ºF (49°C).
M
Melissa NguyenAug 29, 2025
Why is detergent remaining in the dispenser of my Maytag MDB4949SDM?
- J
  Jose MartinAug 30, 2025
  Ensure dishware isn't blocking the detergent dispenser from opening. Verify your detergent is fresh and without lumps. If the cycle is complete, the “Clean” light will be on. If not, close the door and press Start/Resume to resume the cycle.
S
Suzanne FordAug 31, 2025
Why does the Maytag Dishwasher cycle run too long?
- K
  Kayla MayoAug 31, 2025
  Efficient dishwashers can run for up to 3 hours to save water and energy. A water heater setting of 120°F (49°C) is optimal; cooler water will extend the cycle. Certain options, like Heated Dry (approximately 45 minutes), add time. For a faster cycle, use the Quick cycle, which uses more energy and water. Run hot water at the faucet before starting the cycle.
C
christina58Sep 2, 2025
How to improve drying in Maytag MDB4949SDM Dishwasher?
- C
  Christopher RichardsSep 2, 2025
  Plastic and nonstick items are difficult to dry due to their porous surfaces. Towel drying may be needed. Use rinse aid with the Heated Dry option for better drying. Load items properly, ensuring glasses and cups with concave bottoms are placed on a slanted side of the rack. Unload the bottom rack first.
W
wendy61Sep 4, 2025
Why does water remain in the tub of my Maytag Dishwasher?
- E
  Ethan RodriguezSep 4, 2025
  Ensure the cycle is complete (the Clean indicator light will be on). If not, resume the cycle by closing the door and pressing Start/Resume (or pressing Start/Resume and closing the door within 4 seconds for top control models). If connected to a food waste disposer, ensure the knockout plug is removed. Check for kinks in the drain hose, food obstructions in the drain or disposer, and check your house fuse or circuit breaker.
L
Luis CoxSep 6, 2025
How to get rid of odors in Maytag Dishwasher?
- T
  Taylor WigginsSep 6, 2025
  If the dishwasher isn't used daily, run a Rinse cycle with partial loads. To eliminate odors, put 2 cups (500 mL) of white vinegar in a glass measuring cup in the lower rack and run a Normal cycle with the Heated Dry option off (without detergent). Ensure the dishwasher is draining properly.

Maytag MDB4949SDM Specifications

General

Style	built-in dishwashers
Color	monochromatic stainless steel, stainless steel
Cycle Selections	powerblast, auto, normal, quick, rinse
Options/Settings	heated dry, hi temp wash, sani rinse®, control lock, 1-24 hour delay
Delay Start	yes
Number of Racks	2
Cycle Signal	yes
Water Filter	yes
Food Disposer	yes
Sanitize Settings	no
Annual Energy Consumption	270 kilowatt hours
Voltage	120 volts
Current	15 amperes